Cli-mate CLI-AP30 Especificaciones descargar pdf (Pagina 8)

2.3. Safety (OSHA / CCOHS)

a) At all times, installers must adhere to operation safety and health guidelines as outlined by OSHA (USA)

or CCOHS (Canada). For more information please visit www.osha.gov or www.ccohs.ca

b) The installer is responsible for his or her own safety while performing installations, at all times.

c) Those meeting the “Authorized Persons” requirements must also thoroughly READ and UNDERSTAND

this installation manual prior to initiating installation of any Apricus solar water heating product(s).

For any queries contact your local Apricus representative or Apricus directly in North America:

Ph: +1 203 488 8215 Email: [email protected]

d) Evacuated Tubes:

i) Be careful while handling the evacuated tubes, as they will break if knocked heavily or dropped.

ii) Safety glasses MUST be worn at all times when handling evacuated tubes.

iii) If the evacuated tubes are struck by a hard object with sufficient force (ie. branch falling on roof),

they may break. During installation consideration should be taken as to the possible path any broken

glass may take. Protection should be implemented to prevent broken glass from causing injury or

creating walking hazards to those below.

iv) The home owner should be made aware by the installer of the location of the solar collector and the

possible vicinity of broken glass in the event of an extreme storm or object falling on the collector.

e) High Temperatures:

i) When installed in the evacuated tube and in good sunlight, the heat pipe tip can reach temperatures

in excess of 392

F (200

C). At this temperature, touching the heat pipe will result in serious burns.

Thick leather gloves must be worn when handling hot tubes and heat pipes.

ii) In an operational system, if the pump stops during daylight hours the collector header and plumbing

close to the manifold can reach temperatures in excess of 320°F (160°C). ALWAYS use caution when

working near the collector and piping.

f) Metal Components:

i) ALWAYS use caution and wear appropriate personal protective equipment, including gloves, when

working with any and all metal components, especially those with sharp edges.

g) Electrical Connections:

i) Any electrical installation work must be completed by a licensed electrician. Take special care

when working in potential wet environments. Ensure all power outlets, cables and connectors are

protected from water ingress, high humidity and condensation.

Apricus Solar Collector Installation & Operation Manual - USA

Evacuated Tube

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 119 120

Sin comentarios

Cli-mate CLI-AP30 Especificaciones Pagina 8